How to Setup the Aluminum Angle
Spill Berm
Regarding the Spill Berms Multiple Use - Aluminum Angle Spill Berm Setup: Please carefully read and follow the instructions below:
Once the spill berm has been taken out of its storage bag, lay the berm out flat and fold in the sides. At this point the berm should be pulled out to its actual size.
Remove the aluminum angles that are bent to 90 degrees, and lay them alongside each of the pockets that are welded on. The pockets surround the outer perimeter of the berm approximately 2 feet apart.
Slide the berm angles into the pockets from bottom to top with the berm sides folded in and pockets facing up. The exposed part of the angle (not in the pocket) should be placed beneath the berm.
Questions? Call us @ (+1) 772-646-0597 or toll free at (888) 703-9889 or chat with us (chat button displayed below) to discuss your secondary containment requirements.
Aluminum Angle Berm Setup Flyer
As the 90 degree brackets are assembled to the sides, the side wall of the berm will be formed.
Pull the sides out removing any wrinkles in the floor, and your berm is ready for use.
When parking a vehicle or trailer on the berm, remove as many angles as necessary and fold the section down. Replace the aluminum angles when the vehicle is parked.
Options: Consider the use of drive over mats or ground liner to extend the life of your berm.
Call us at any time @ (+1) 772-646-0597 or toll free at (888) 703-9889 to discuss your aluminum angle spill berm setup or spill containment requirements.
Other Secondary Containment Options:
- Spill Berms Multiple Use
- Drive-Through Berms
- Decontamination Pools
- Spill Basins
- Secondary Spill Containment
